RE: [DML] No Fuel to injectors

["John Hervey" <john@xxxx>]

Dave, Make sure the primary pressure regulator on the lower right side of
the fuel distributor doesn't have something holding it open. Then keep in
mind the injectors have a fine wire mesh screen inside them that could get
clogged up and they take 50 lb's to open them. I would take one of the
injector lines off the injector and see if gas is flowing.
John Hervey


-----Original Message-----
From: Delorean17@xxxx [mailto:Delorean17@xxxx]
Sent: Monday, May 19, 2003 6:08 PM
To: dmcnews@xxxxxxxxxxxxxxx
Subject: [DML] No Fuel to injectors


Hi,
I finally had a chance to work on this guys car today. The fuel
distributor is brand new and I have fuel where the feed line enters the
distributor. All of the lines have been double checked and are hooked up
correctly. I remove several of the injectors and place them in bottles with
the fuel pump running. I feel resistance on the air sensor plate but I only
get a dribble of fuel out of each injector line. I have double checked
every
connection on the car and they are hooked up properly. I also installed a
new pump today but had the same results.
I remember hearing that fuel pressure could sometimes be cut
off
near the fuel filter if it is tightened too hard. Is that a possibility?
What else could be causing this problem? I must have this car out of my
garage in 2 days. HELP ME!!

Thanks


Dave.