Re: parts cross-compatibility

[srubano@xxxx]

Sorry if you misunderstood me but...what I meant was that you guys 
were manufacturing NEW arms and telling Walt that it sounded like to 
much work to modify a pinto lower arm if it did fit the Delorean (his 
ORIGINAL post, go back and read it) and to just wait for the new ones 
that are being made. 

Sorry if it sounded wrong, I should have spaced that line down.

I take from your post that you didn't want "attention" towards the 
project?? If that was so then if it was so "TOP SECRET" about it I 
doubt that it would have been brought to my attention without 
saying "just between you and I". I did not jump to any conclusion as 
you said as the way you just did.

SORRY for the confusion,
Steve


--- In dmcnews@xxxx, seanm@xxxx wrote:
> Syeve you said:
> 
> > DMC Joe said that he was in the process of getting the lower 
> control 
> > arms remanufactured by a machine shop so I believe they would be 
> > readily avail soon. Sounds like to much work to go through to cut 
> > down the Pinto's control arm and hope it aligns properly.
> > 
> > I think the pinto rack is to short unless someone made adapters 
for 
> > it to extend it.
> > 
> > Steve
> 
> I am part of the team that is manufacturing this new lower control 
> arm FROM SCRATCH. NO WAY are going to machine down some old pinto 
> part. 
> Thanks
> Sean
> 02912