[DML] Re: Permanate addition to engine block; where to tap a new hole?

["Harold McElraft" <hmcelraft@xxxxxxx>]

Sounds like a job for the Dremel - with time and patience and the 
special bits.

Harold McElraft - 3354


--- In dmcnews@xxxxxxxxxxxxxxx, "jmlaux83" <jmlaux83@xxxx> wrote:
> I had a broken off screw from the air intake manifold to the 
engine 
> block. After some research I decided to use a screw extractor. I 
made 
> sure to soak the bolt for the last week with liquid wrench. Now 
the 
> screw isnt a problem, it is the new broken off extractor in it 
> is!!!!!!! There is no way I can get that out, so where is another 
> place I could tap a hole for another screw? The broken off one is 
on 
> the right hand side closest to the rear fascia. I wish that I just 
> tapped a smaller hole inside the old bolt intead of putting my 
faith 
> in a $3 extractor which now will cost me a lot of $$$$$$ >:(




To address comments privately to the moderating team, please address:
moderators@xxxxxxxxxxx

For more info on the list, tech articles, cars for sale see www.dmcnews.com

To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews 
Yahoo! Groups Links

<*> To visit your group on the web, go to:
     http://groups.yahoo.com/group/dmcnews/

<*> To unsubscribe from this group, send an email to:
     dmcnews-unsubscribe@xxxxxxxxxxxxxxx

<*> Your use of Yahoo! Groups is subject to:
     http://docs.yahoo.com/info/terms/