[DMCForum] Re: clutch master cylinder retaining bolts

["Matt Spittle" <mds328@xxxxxxx>]

Nah, it wasn't riv-nuts.  It was the most half-assed thing I had ever
seen.  On the trunk side, there are 2 nyloc nuts.  On the footwell
side, there are 2 phillips head bolts; not glued in place or anything.  

It practically makes removing the clutch master cylinder a 2 person
job if you don't have vice grips.

Matt
#1604

--- In DMCForum@xxxxxxxxxxxxxxx, Marc Levy <malevy_nj@xxxx> wrote:
> I have not had mine off, but Riv-Nuts are common on
> the DeLorean.  John Hervey sells replacements, and the
> tool to install them.  Good investment for any
> DeLorean owner.
> 
> 
> --- Matt Spittle <mds328@xxxx> wrote:
> 
> > Are the bolts that hold the clutch master cylinder
> > in place supposed
> > to be glued to the body?  When I tried to remove
> > mine tonight, they
> > just kept spinning, and I had to eventually put a
> > vice grips on the
> > bolts to remove the master cylinder.  I did have a
> > lot of fluid in the
> > driver's footwell area.  Could the fluid have
> > dissolved the epoxy?? If
> > not, it really seems like a half-assed design.
> > 
> > thanks,
> > 
> > Matt
> > #1604
> > 
> >
> 
> __________________________________________________
> Do You Yahoo!?
> Tired of spam?  Yahoo! Mail has the best spam protection around 
> http://mail.yahoo.com

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.