[DMCForum] Re: Intake manifold removal
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[DMCForum] Re: Intake manifold removal
- From: "mw98gt" <mw98gt@xxxxxxxxxxx>
- Date: Sun, 10 Oct 2004 20:49:53 -0000
So which way is better, remove distrubituor or remove fuel lines?
Will fuel be all over the place if i remove the lines, or same
differnce?
--- In DMCForum@xxxxxxxxxxxxxxx, DMCVIN6683 <dmcvin6683@xxxx> wrote:
> Just leave the fuel distributor attached to the air meter where
it is
> and dont mess with it, remove all fuel lines from the distributor
THEN
> remove the air meter assembly with the fuel distributor as a whole
unit.
>
> Mark V
>
>
>
> On Sunday, October 10, 2004, at 10:04 AM, Walter Coe wrote:
>
> >
> > Oh yeah, I wouldn't have remembered that 3rd screw unless I
> > saw it in the way. The fuel line has to come off to access
> > that screw.
> >
> > Also a big caveat: When you lift the fuel distributor from
> > the air metering unit, immediately put your finger under the
> > bottom center to prevent the plunger from falling out. Some
> > are more prone to dropping out than others. It is good to
> > wrap it in tape or something to hold it in. The problem is
> > that the whole mess will be wet with fuel which stops tape
> > from sticking and even removes the paint. (BTW, I would be
> > curious to see a zinc or chrome plated fuel distributor if
> > that wouldn't muck up the internals.)
> >
> > I recommend not reusing copper crush washers if at all
> > possible; tho, I often break this rule. There is a
> > procedure for heating them on a wire with a propane torch
> > until cherry red and then let them cool slowly. That is
> > supposed to recondition the copper, per se. I doubt the
> > procedure would help aluminum crush washers. It is possible
> > someone used those on your car.
> >
> > Walt
> >
> >
> >
> >
> >
> > Yahoo! Groups Links
> >
> >
> >
> >
> >
> >
> >
Yahoo! Groups Sponsor |
ADVERTISEMENT
| |
|
Yahoo! Groups Links
Back to the Home of PROJECT VIXEN