[DMCForum] Re: 24valve 3.0 PRV
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[DMCForum] Re: 24valve 3.0 PRV
- From: "Christophe Vieira" <88mph@xxxxxxxxxxxx>
- Date: Fri, 08 Oct 2004 22:20:42 -0000
Hello Martin and All,
Oops, I have not written clearly, I wanted to say that 24v PRV
installation is possible in the DeLorean as some people here have
already put this engine in an Alpine A310, car which has the same
setup as the DeLorean. Sure, the A310 and also the A610 didn't have
a 24v PRV. I have to check but I'm not sure that the R30 and the
DeLorean have the same lower crankcase. I'm sure about the A310.
There are several engines for Venturi, the one you speak about is
the one installed in the Venturi 400 Trophy or GT and its gearbox is
a Hewland. I know some persons in the Venturi community and I've ask
for the price for a complete 400 Trophy/GT engine and it's about
$20.000 without installation and tuning but you get 408hp? ;o)
In the Venturi, the gearbox is behind the engine, it's the contrary
of the DeLorean.
In the XM/605 then engine is installed transversely and in the
Renault Espace, it is longitudinally. The gearbox of the XM and 605
are almost the same. Personally, I do not advice you to use the
engine of the twin turbo Renault Safrane, its city consumption is
very high, about 27 liters per 100 km and it is a 12v engine.
Best regards from France,
Chris
--- In DMCForum@xxxxxxxxxxxxxxx, Martin Gutkowski <martin@xxxx>
wrote:
>
>
> Christophe Vieira wrote:
>
> > Yes, engine and gearbox are almost French parts as this engine
has
> > been used in many different cars (Peugeot 505, 604, 605, Citroen
XM,
> > Alpine A310, A610, all Venturi...).
> > It's possible to swap the crankcase on the engine as some Alpine
A310
> > use the 24V PRV in the same position as the DeLorean.
> > I've been told by an Alpine specialist that you just have to
unbolt
> > the crankcase off the 24v PRV and bolt on the one from the
DeLorean
> > engine without any kind of problems.
>
> The Alpine never had the 24 valve PRV - it's too late for the 310
and
> the 610 had the 3 litre 12 valve turbo lump. The Atmo had the
carbed
> 2.85 and the GTA V6 Turbo had the same engine as the 25 turbo -
the
> 2458cc turbo. All the alpine's use the same mounts as the 25 which
are
> the same as Bill Robertson's - identical but the mounts are in the
> middle. The DeLorean crank case is RENAULT 30 - the sump is
visually
> identical but the D's is slightly deeper needing those spacers on
the
> oil pickup and a unique dipstick tube. The only 24 valvers were
> available as an option in big Peugeot, Citroen and Renaults from
95-97
> and was then replaced across the board by the 3 litre 24v 60
degree PSA
> V6 which is still in use today. As far as I know the gearbox in
the
> Citroens is very different, as it was in the Renault Espace for
example
> where the engine sits transversely. The Venturi is a lore unto
itself,
> with a heavily modified 24 valve 3litre twin turbo, twin
intercooled
> rear mounted PRV on the end of a UN1. The heads in the Venturi
engine
> are not the same being twin-cam I believe. However, all PRV's
including
> the 24valver carry the same bottom end as the turbo lumps meaning
with a
> change of pistons, you can blow those engines with no fear of
damage.
> The rarest version is in the Renault Safrane which had a
sequential twin
> turbo setup - this was reserved for the french market alone. I've
made a
> friend in the guy who runs www.renaultalpine.co.uk who is dropping
a 24
> valver in his Atmo
>
> Martin
Yahoo! Groups Sponsor |
ADVERTISEMENT
| |
|
Yahoo! Groups Links
Back to the Home of PROJECT VIXEN