[DMCForum] Re: Reaching Thermal Vacuum Switch
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
[DMCForum] Re: Reaching Thermal Vacuum Switch
- From: "content22207" <brobertson@xxxxxxxxxxxx>
- Date: Sat, 02 Oct 2004 02:27:18 -0000
If you remove the exhaust crossover pipe the thermal vacuum switch is
super easy to reach from below (and the ignition distributor, heater
core shutoff valve, heater core takeoff barb, other coolant
distribution pipe sensors, etc). No joke -- you'll be looking right at
them.
Bill Robertson
#5939
>--- In DMCForum@xxxxxxxxxxxxxxx, "Walter Coe" <Whalt@xxxx> wrote:
>
> The main vacuum leak to worry about is that vacuum switch
> with 3 hoses on it. Make sure it isn't leaking. They can
> leak around where the metal is crimped around the plastic.
> If it is loose, it leaks. I didn't realize this was a
> problem on mine until I already had the intake manifold back
> on. So I gooped it up by reaching under there with my
> fingers. I was surprised I could get my hand in there far
> enough. But better to do it while you have the manifold
> off.
>
Yahoo! Groups Sponsor |
ADVERTISEMENT
| |
|
Yahoo! Groups Links
Back to the Home of PROJECT VIXEN