[DMCForum] Re: McQuinlan's (?) Fingers

["content22207" <brobertson@xxxxxxxxxxxx>]

Fellow I work with lost his making doors with a moulding head cutter
in the table saw (extremely dangerous -- much better to use a proper
shaper, your unfortunate experience notwithstanding).

Did you see pics of my carb adapter? Cut it myself from a block of
aluminum using steel bladed wood working tools. Put up about the same
resistance to those blades as oak to carbide. Consistency was closer
to pine (didn't chip at all). Ran the tools full speed yet the blades
never got hot.

Bill Robertson
#5939

>--- In DMCForum@xxxxxxxxxxxxxxx, "wannadelorean" <mcquinlan@xxxx> wrote:
> I lost mine on a large wood shaper (making raised panel doors for 
> custom cabinets in my house).  I lost all 3 fingers at the first 
> knuckle.  Couldn't save them (shredded).  Wood working is a hobby of 
> mine but I'm doing less and less all the time.  My shop is being 
> relocated to make room for a Delorean.  It is a little harder to 
> lose appendages on car.  Took me a good year to learn to type again 
> and they hurt all the time.  
>

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.