[DMCForum] Re: Back to working on the front end

["cruznmd" <racuti1@xxxxxxxxxxxx>]

There are zirc fitting on the upper and lower control arms for the 
ball joints. Mine were invisible because they were covered with road 
gunk.

The lower one is completely upside down, inside the recess. Just 
hit 'em with a NON-pneumatic grease gun.

Rich A.
#5335



--- In DMCForum@xxxxxxxxxxxxxxx, Travis Goodwin <tgoodwin@xxxx> wrote:
> Well, all I can say is thank God for impact wrenches, otherwise my 
driver's
> side hub and rotor would still be attached. Not to mention the fact 
that the
> hub nut was originally removed with a chisel and has huge chunks 
taken out
> of it. Luckily it came off without too much trouble.
> 
> I'm wondering a few things...
> 
> 1. Are there any lubrication points for the front end or front 
suspension?
> 2. If replacing the rotors does not fix my vibration issue, then 
I'm looking
> at an alignment. What was the name of the procedure recommended for 
our
> cars?

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.