Andrei, Just got your call... was working late on the server. Here's the deal. The guy's name is Clarke Huber, phone number 386-848-1091 cell, or 386-437-1828 at the warehouse where it is. You'll probably have better luck with the warehouse number. He asked if you could pick it up on Saturday, sometime around noon or 1. Is that when you're having the get-together? If it is, I'll ask him if he can be there Friday instead, or if we can push it off a bit, whichever works out better for you. Here's his directions: Take the BUNNEL exit off of I-95 (Route 1). Take Rt 1 WEST (he said it's actually NORTH) for 9-10 miles. You'll see a Hess gas station on the right, then a biker bar about a mile or so past that (also on right). The road curves left, and after about 1/2 mile, you'll see some salvage yards on the left, and a small sign for STATE ROAD 304. Make a LEFT on STATE ROAD 304. After about 4 or 5 miles, you'll see a small bridge. About 50 feet after the bridge, make a LEFT on HUDSON ALLEN ROAD (a dirt road). Stay to the right, all the way to the end, where you will see his warehouse. If you pass the steel gate you've gone too far. He took it apart for transport, but most of the leads are not hard to put back on. It's going to need tanks of calibration gas to be accurate, but if you're just using it to tune in the lowest CO, then it would be fine -- just tune it to whatever the lowest reading is and don't worry about the actual number. I will be home tomorrow, and I'll try giving you a call on your cell. -Dave 412-822-7385 [Non-text portions of this message have been removed] To unsubscribe from this group, send an email to: DMCForum-unsubscribe@xxxxxxxxxxxxxxx _____ Yahoo! Groups Links * To visit your group on the web, go to: http://groups.yahoo.com/group/DMCForum/ * To unsubscribe from this group, send an email to: DMCForum-unsubscribe@xxxxxxxxxxxxxxx <mailto:DMCForum-unsubscribe@xxxxxxxxxxxxxxx?subject=Unsubscribe> * Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service <http://docs.yahoo.com/info/terms/> .
<<attachment: winmail.dat>>