--- In DMCForum@xxxxxxxxxxxxxxx, "Cohee, Michael" <mcohee@xxxx> wrote: > I am trying to ask one question a day :-) I have tightened a few of the body bolts in the car where the seat belts are. A couple were very loose. As I was tightening I realized that I had no idea how tight they should be. How tight should I make them? Since you can't see the other end on these I don't want to tighten so much that I am stripping out the fiberglass and then the bolt would just tear through the fiberglass and spin...I am guessing there is some sort of nut/washer on the other end of these bolts. Is there a torque I should go for or should I just tighten till snug.... > > Do you need to be a contortionist to do the two in the rear of the car? > > thanks. > Mike C Hi Mike. Tighten till snug, as you say. Resist the temptation to overtighten. It would stress the fiberglass. To do the ones in the rear, the rear fascia has to be off. Then you'll see a four inch circular hole just big enough to get your hand and a wrench in. Rick ------------------------ Yahoo! Groups Sponsor ---------------------~--> Get A Free Psychic Reading! Your Online Answer To Life's Important Questions. http://us.click.yahoo.com/Z_CBYA/vB5FAA/AG3JAA/HliolB/TM ---------------------------------------------------------------------~-> To unsubscribe from this group, send an email to: DMCForum-unsubscribe@xxxxxxxxxxxxxxx Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
<<attachment: winmail.dat>>