> On the bottom i see > a screw and thats it. That IS it. You take the screw out and inject your favorite oil in the hole. But you may run into problems. First you need to disconnect the lower speedo cable from the angle drive. Then you rotate the angle drive until the screw faces up. But more often than not any angle drive that I have tried to lube has the housing so stuck that it won't rotate. Be careful not to gouge/scrape it beyond recognition with pliers. It helps to protect the speedo cable threads by using a ring from an old speedometer cable to screw over it. (Common junk yard item). Then you have an expendable surface that you can grab with pliers. It helps to liberally pre-soak in your favorite penetrant oil. And then you might get lucky and the thing just rolls over and says, "oil me". My secret for getting oil in the screw hole is a broken off needle used to put air in footballs/basket balls. I jab the broken end into a tube of 90W gear oil and then put the other end in the angle drive. It helps to spin the cable going in while you "stuff" it with oil. I've heard of other methods like injecting with grease, white lithium, motorcycle chain oil, etc. Walt ------------------------ Yahoo! Groups Sponsor ---------------------~--> Get a FREE REFINANCE QUOTE - click here! http://us.click.yahoo.com/2CXtTB/ca0FAA/i5gGAA/HliolB/TM ---------------------------------------------------------------------~-> To unsubscribe from this group, send an email to: DMCForum-unsubscribe@xxxxxxxxxxxxxxx Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
<<attachment: winmail.dat>>