> Let me ask you this- how is the temperature gauge hooked up? I'm in pretty much the same boat you are. I only have the tiny schematic that comes in the service manual. If the gauge itself is fine then look for bad connections in the binnacle. It uses a funky ribbon/lasagna printed circuit that doesn't always make the best connection. The other likely bad spot is like where Mike said on the upper right side of the engine block toward the rear window. Make sure the wire didn't come loose and the sender is good. But I don't see how bad wiring would make the needle point in the 5 o'clock position. Walt To unsubscribe from this group, send an email to: DMCForum-unsubscribe@xxxxxxxxxxxxxxx Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
<<attachment: winmail.dat>>