RE: [DMCForum] Grinding in reverse...

["timnagin" <timnagin@xxxxxxxxxxxxxx>]

That's exactly what I was thinking.  We did a complete brake upgrade on a
local owner's car and the driver's front rotor was stuck on the car.  When
it was finally forced off the bearing fell in pieces to the garage floor.

Greg


-----Original Message-----
From: DMCForum@xxxxxxxxxxxxxxx [mailto:DMCForum@xxxxxxxxxxxxxxx] On Behalf
Of Chris Almy
Sent: Sunday, January 08, 2006 12:54 PM
To: DMCForum@xxxxxxxxxxxxxxx
Subject: RE: [DMCForum] Grinding in reverse...

I had a similar problem, but going forward. Once I replaced the front 
bearings, the car now drives straighter too! When I pulled the old ones 
off, one of the bearings on the problem wheel completely separated! I think 
water managed to get in and cause the bearing to fail.

Chris
VIN 4099

At 12:30 PM 1/8/2006 -0500, you wrote:
>When you had that tire off the ground, did you wiggle the tire to see if
>there was any play in the bearing?
>
>Greg

---

YAHOO! GROUPS LINKS

•  Visit your group "DMCForum" on the web.
   
•  To unsubscribe from this group, send an email to:
   DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
•  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

---