[DMCForum] Steering bush replacement and re-assembly

["Frederik Van Acker" <frederik.van.acker@xxxxxxxxxx>]

Hi,

As many I needed to replace the steering bush as it has completely 
worn out. I replaced it with the  new durable upgrade but now 
encountered a problem: It was a bit difficult to get the steering 
column disconnected from it's coupling (24 years of rust!) but 
finally it loosened up. I placed the bushing but while trying to 
reconnect the steering column to the coupling it seems like my 
steering column has shortened (??). I mean the column does not go 
far enough down through the hole to connect the coupling to it. I 
know the column can slide of course (I've loosened the 17mm bolts 
behind the steering wheel) but even in it's maximum lower position 
the steering column stem hardly reaches the hole.

Is there a procedure anywere or can you guys help me out? Did I miss 
something? Can't move the car now as I have no steering! ;-)


I've traced some previous posts but most of them were about 
disconnecting the lot, not re-assembling it...

Thanks in advance from far away in Belgium.

Frederik
VIN #02330

---

YAHOO! GROUPS LINKS

•  Visit your group "DMCForum" on the web.
   
•  To unsubscribe from this group, send an email to:
   DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
•  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

---