[DMCForum] Another spring question

["Josh Porter" <joshp1986@xxxxxxxxx>]

I finally got the spring and everything off and the new arm on. I am 
at the part where I am supposed to reinstall the coil spring. I have 
run into a problem with the compressor. It won't fit back in. I used 
my ball joint separator to pry the sway bar out and when I did the 
whole thing just fell straight down on the ground. Is it safe to put 
the spring in a vice to get the compresspr off? I mean just hold it 
with the vice, not compress it any more. If not then I'm stuck..again.

Josh
10989

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.