[DMCForum] Re: Does the lock module know anything?

["Toby Peterson" <tmpintnl@xxxxxxxxx>]

Andrew - As the designer, perhaps I should chime in here.  I have 
noted on several cars that there is some degree of interference 
between some of the lock rods and door structure.  If you watch 
carefully while you cycle the locks (taking precautions as noted in 
the instructions), you may see lock rods rubbing on the grab handle 
brackets, or other structure or bracketry.  The interference is 
resolved by bending the rods slightly, grinding the brackets, or a 
combination of the two steps.  In regards to the actuator rod angle, 
I would recommend that you put a slight bend it it so that it is 
parallel to the forward lock rod where you attach them together with 
the clamp block.  The picture in the instructions shows it bent 
slightly.  This seems to allow it to work a little smoother.  It is 
also possible to eliminate the forward lock from the equation while 
still keeping the actuator rod in place.  I can send you a picture of 
that modification if you'd like.  Please feel free to email me either 
on or off the Forum and we can sort out the issues that you are 
finding.  You will enjoy the Elite very much, by the way.

As an open comment to all, if you have a speciic problem or question 
with any particular vendors parts or procedures, the first place you 
should go is that vendor.  Just a thought to save time and get the 
best answer possible.  Life is good!

Toby Peterson
DeLorean Parts Northwest, LLC 
www.delorean-parts.com


--- In DMCForum@xxxxxxxxxxxxxxx, Andrew <aos+yahoo@xxxx> wrote:
> 
> I did that, and it's helped a little, but not enough.  It looks 
like the difficulty is primarily in pulling the front lock 
mechanism.  I know some people have in the past settled for 
disconnecting the front lock when it causes problems, but that's not 
an option here due to the way DPNW's kit hooks on.
> 
> The problem seems to be exacerbated by the angle of the connecting 
rod in the DPNW kit.  Did you find that you needed to bend the rod a 
little to bring the rods more into alignment?  Any tips here for what 
works best?
> 
> I'm tired of fighting with the keyless entry receiver I've got.  
It's not behaving right (even electrically internally, and I think 
it's causing its own problems here.  I think it's time to upgrade to 
the Wings-a-Loft Elite.  :)
> 
> -andrew

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.