RE: [DMCForum] Need a bearing..

["Scott Mueller" <scott.a.mueller@xxxxxxxxx>]

A spacer between the crank and the bearing should be quick and easy to turn
on a lathe.

-----Original Message-----
From: Marc Levy [mailto:malevy_nj@xxxxxxxxx] 
Sent: Monday, April 04, 2005 4:41 PM
To: DMCForum@xxxxxxxxxxxxxxx
Subject: RE: [DMCForum] Need a bearing..


Stack?  I don't think that is possible for this
application.

The is for the pilot bearing, and there is about 1/2
inch gap between the end of the input shaft and the
crankshaft.

I am left with 2 other options..  Make a hub to bring
the bearing out to reach the input shaft, or have the
input shaft extended (or make a new one).

Both seem like expensive options.  :(

Thanks for checking Greg.. I appreciate it!


--- timnagin <timnagin@xxxxxxxxxxxxxx> wrote:
> 
> I called a few places here that specialize in this
> and they didn't have
> anything that wide.  Several suggested stacking
> three 17 x 35 x 10 together
> and using a bronze bushing to fill in some of that
> space, if you can.  The
> largest they could find was a 17 x 35 x 14.
> 
> Greg
>


            
__________________________________ 
Yahoo! Messenger 
Show us what our next emoticon should look like. Join the fun. 
http://www.advision.webevents.yahoo.com/emoticontest


  _____  

Yahoo! Groups Links


*      To visit your group on the web, go to:
http://groups.yahoo.com/group/DMCForum/
  

*      To unsubscribe from this group, send an email to:
DMCForum-unsubscribe@xxxxxxxxxxxxxxx
<mailto:DMCForum-unsubscribe@xxxxxxxxxxxxxxx?subject=Unsubscribe> 
  

*      Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service
<http://docs.yahoo.com/info/terms/> . 




[Non-text portions of this message have been removed]

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.