[DMCForum] Re: Replace Pilot Bearing (Remating the Transmission)

["content22207" <brobertson@xxxxxxxxxxxx>]

This is the voice of experience talking: do not use the transmission
mounting bolts to pull it back to the engine. You'll bind and deform
those tiny splines without even feeling any resistance. I ruined two
brand new clutch discs that way. I was able to wiggle the second
failed installation to within 1/2"-3/4" of the block and STILL bound
the stupid thing. It's very different from installing a 10 spline clutch.

Bill Robertson
#5939

>--- In DMCForum@xxxxxxxxxxxxxxx, "minox8x11" <mpaine@xxxx> wrote:
> 
> Forgive the beginner... What tools do I need to remove/reinstall the
> pilot bearing?
> 
> Michael Paine
> Vin 6067 - trying to get the clutch/1&2nd roll pin/TABs done in time
> for the Spring Social

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.