RE: [DMCForum] Replacing Door/Roof Seals

[Travis Goodwin <tgoodwin@xxxxxxxxxxxx>]

Drill the rivets our carefully. Make sure you put something to protect the
torsion bar.

Unfortunately, the drill is the only way to go.

-----Original Message-----
From: Michael Babb [mailto:mcbabb@xxxxxxxxx] 
Sent: Tuesday, March 29, 2005 4:23 PM
To: dmcnews@xxxxxxxxxxxxxxx
Cc: DMCForum@xxxxxxxxxxxxxxx
Subject: [DMCForum] Replacing Door/Roof Seals



Hey gang,

I am looking at replacing the weather seals that mount to the uppermost
part of the door and form the seal between the door and the T-panel.
These are held in with pop rivets.

Questions: 

How the heck do you get these pop rivets out? I was looking at them with
the drill, but the fear of nicking the torsion bar with a drill bit made
me hold of on this route . .  .

Once you get the rivets out and are ready to mount the new parts, do
people usually just screw these in, or are pop-rivets the way to go . .
.don't want to have to go through too much pain if I have to do this
again in the future.

Michael & 3472





 
Yahoo! Groups Links

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.