[DMCForum] Re: Clutch / Roll pin Replacement

["therealdmcvegas" <dmcvegas@xxxxxxx>]

I know that the one time that Rob Grady posted to the list, he wrote
about using hylomar to seal the trans case back up.

DMCNews as a write up about observations made:
http://dmcnews.com/Techsection/manualtrans.htm
But other than that, I don't really recall anyone else who's dove into
the transmission. It's still a ways off before I install an ATB, and
bigger input shaft.

-Robert



--- In DMCForum@xxxxxxxxxxxxxxx, Michael Paine <mpaine@xxxx> wrote:
> Hey all
> 
> First post... it's a request for help...
> 
> I need to replace the roll pin for the 1st & 2nd gear shift fork. I
also need to
> replace the clutch... Might as well do the trailing arm bolts while
in there too.
> 
> I have 2 jack stands and a 3 ton floor jack... No garage, but a flat
driveway. I
> CAN get access for a day to a bay of a "garage" that has a lift. I
can't leave
> the car overnight - the lift will go up about 4 ft using long pads
that raise on
> both sides in the wheel base. I would be free to roll up or down the
length of
> the car in the center. 
> 
> What tools do I need to reace the clutch and where do I get the
sealant for the
> tranny case??
> 
> Help for a transmission noob...
> 
> Thanks,
> 
> Michael Paine
> vin 6067

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.