RE: [DMCForum] roof support.. was: Tampa tech session

["timnagin" <timnagin@xxxxxxxxxxxxxx>]

My concern with using screws would be what they bite into.  The fiberglass
in that area is not that thick, and the foam inside won't hold anything.
Let me know if you would like to see a cross section of this area as I have
recently sliced and diced one to repair my car.

Greg




-----Original Message-----
From: Jack Stiefel [mailto:jackstiefel@xxxxxxxxxxxxxxxxxxx]
Sent: Sunday, October 24, 2004 5:47 PM
To: DMCForum@xxxxxxxxxxxxxxx
Subject: RE: [DMCForum] roof support.. was: Tampa tech session



I will let him describe it in detail, but basically you remove the t-panel,
torsion bars, and louvers.  Then you pry down the top of the car and drill
out some small holes.  Last you put in screws to hold everything in place.
We did Samuels car and it made a big enough difference.

Jack Stiefel
www.fmtimemachine.com
Direct listen link: www.live365.com/stations/radiocape

-----Original Message-----
From: timnagin [mailto:timnagin@xxxxxxxxxxxxxx]
Sent: Sunday, October 24, 2004 5:28 PM
To: DMCForum@xxxxxxxxxxxxxxx
Subject: [DMCForum] roof support.. was: Tampa tech session


What exactly is Walter's procedure?  I recently saw a car with, I think,
four small pop-rivets across the top of the rear piece.  They didn't really
look large enough to do anything.

Another owner and I were discussing drilling all the way through the rear
support, through the fiberglass underbody, and install bolts.  I know about
the interference issues with the T-panel and headliner.  Mine isn't lifting
right now, and has tons of resin all over the place, but I am considering
doing this while I am in there.

What do you think?

Greg



-----Original Message-----
From: Jack Stiefel [mailto:jackstiefel@xxxxxxxxxxxxxxxxxxx]
Sent: Sunday, October 24, 2004 8:34 AM
To: DMCForum@xxxxxxxxxxxxxxx
Subject: RE: [DMCForum] Re: Tampa tech session



I have a non working drivers side window and I believe I need the top of
the t-panel lowered and screwed down per Walters directions.  I am not
sure if those little projects can be done in conjunction with other
projects.

Jack





Yahoo! Groups Links












Yahoo! Groups Links

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.