Re: [DMCForum] Re: Walt... aircon & springs

[Andrei Cular <acular@xxxxxxxxxxxxxxx>]

Walter Coe wrote:

>>I still have Dave;s engine analyzer, if we can get a few
>>    
>>
>people that
>need it at the same time I would bring it up to Tampa for a
>weekend tech
>session.
>
>Well, if we could run it off an inverter while it is mounted
>to my luggage rack, then maybe we could diagnose my poor
>acceleration.  But I dont think Dave would approve.
>  
>
If you could find a nice open road, we could rent a car put it in the 
trunk and just drive backwards with it hooked to your car.  I think 
Strickland and I got a cavlier up to 50-55mph in reverse down a 1/8mile 
strip, and with a nice low reverse it should keep up with your stock 
automatic.


>Maybe Misha would care to host a club meeting?  We could all
>show up & try to figure out what is wrong with his car.  I
>am curious to see your TIG welder again.  I'd like to have
>one if I were any good at it.  I suppose I would have to get
>one of my own and practice, practice, practice.
>
>Walt
>
>  
>
Or if the cars will make it down here I should have a nice shop to work 
in by next weekend.  This Sat I am picking up a 15'x30' freestanding 
spraybooth to be my workshop.  Then hopefully before x-mass  I can get 
to NJ to pick up a couple lifts, 1 two post, and a 4 post.

Andrei


Andrei

Yahoo! Groups Sponsor

ADVERTISEMENT

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.