Re: [DMCForum] Re: 10 Degress BTDC Factory Timing Spec (Martin G)

From: Martin Gutkowski <martin@xxxxxxxxxxxxxx>
Date: Fri, 14 May 2004 10:59:51 +0100

If it was not meant as a car engine, just to run a pump, then this would make sense. Martin Jim Strickland wrote: >3 to 4,000RPMs?? who the hell never crosses 3000rpm? > >I'm rarely under 3000rpms unless I'm idling. > > >
Yahoo! Groups Links To visit your group on the web, go to: http://groups.yahoo.com/group/DMCForum/ To unsubscribe from this group, send an email to: DMCForum-unsubscribe@xxxxxxxxxxxxxxx Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.

References:
- Re: [DMCForum] Re: 10 Degress BTDC Factory Timing Spec (Martin G)
  - From: Jim Strickland

Prev by Date: Re: [DMCForum] Re: Fuel system updates - help!! long long long...
Next by Date: [DMCForum] B28E/F how to tell them apart?
Previous by thread: [DMCForum] Re: Potentially Low Rev'ing PRV (Jim S)
Next by thread: Re: [DMCForum] Re: 10 Degress BTDC Factory Timing Spec (Martin G)
Index(es):
- Date
- Thread

Back to the Home of PROJECT VIXEN

Copyright ProjectVixen.com. All rights reserved.
Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive DMCNews Mailing List Archive DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated