Re: [DMCForum] Bosch test rig

["Dave Stragand" <dave.stragand@xxxxxxxxxxxxxxx>]

It doesn't matter which position the switch is in, but the higher pressure is sytem pressure, and the lower one is the control pressure.  If they are the same, that's bad.  =)
  ----- Original Message ----- 
  From: cruznmd 
  To: DMCForum@xxxxxxxxxxxxxxx 
  Sent: Friday, April 23, 2004 5:40 PM
  Subject: [DMCForum] Bosch test rig


  John Hervey sent his test rig to me.

  I have it installed between the top of the fuel dist. and the large 
  port on the CPR. The valve is toward the CPR.

  The valve only has "on" and "off", not 3 positions, "off", "control 
  pressure" and "main pressure" like the manual states.

  Which pressure am I measuring when the valve is "off" and which am I 
  measureing when the valve is "on"?

  I'll try to post a photo of it installed so you can tell me if I have 
  it right. I'm pretty sure it's installed correctly, but I'm not sure 
  which I'm reading and when.

  thanks,

  Rich



------------------------------------------------------------------------------
  Yahoo! Groups Links

    a.. To visit your group on the web, go to:
    http://groups.yahoo.com/group/DMCForum/
      
    b.. To unsubscribe from this group, send an email to:
    DMCForum-unsubscribe@xxxxxxxxxxxxxxx
      
    c.. Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 



[Non-text portions of this message have been removed]

---

Yahoo! Groups Links

• To visit your group on the web, go to:
  http://groups.yahoo.com/group/DMCForum/
   
• To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
   
• Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.