RE: [DMCForum] Idle adjustment tool question

["Travis Goodwin" <tgoodwin@xxxxxxxxxxxx>]

I found them at Northern and Sears. The whole set of 6" hex at Northern is
about $9.

> -----Original Message-----
> From: Walter Coe [mailto:Whalt@xxxxxxx]
> Sent: Wednesday, September 17, 2003 12:27 PM
> To: DMCForum@xxxxxxxxxxxxxxx
> Subject: Re: [DMCForum] Idle adjustment tool question
> 
> > What size allen wrench is needed to adjust the idle mix screw?
> 
> Like Samuel said, mine is a long T-handle that was part of a set.  They
> are
> common at Sears, NAPA, Snap-On, etc.  The one you need is a 3mm.  You
> could
> buy just one, but it is really handy to have the whole set.  I use the
5mm
> to get cold start valves off.
> 
> Walt
> 
> 
> 
> To unsubscribe from this group, send an email to:
> DMCForum-unsubscribe@xxxxxxxxxxxxxxx
> 
> 
> 
> Your use of Yahoo! Groups is subject to
http://docs.yahoo.com/info/terms/



Yahoo! Groups Sponsor	 

ADVERTISEMENT
 
<http://rd.yahoo.com/M=194081.3897168.5135684.1261774/D=egroupweb/S=170512
6215:HM/A=1754016/R=0/SIG=11pv1u2ju/*http://www.ediets.com/start.cfm?code=
30529&media=atkins> click here	
 
<http://us.adserver.yahoo.com/l?M=194081.3897168.5135684.1261774/D=egroupm
ail/S=:HM/A=1754016/rand=442215322> 	

To unsubscribe from this group, send an email to:
DMCForum-unsubscribe@xxxxxxxxxxxxxxx



Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service
<http://docs.yahoo.com/info/terms/> .

<<attachment: winmail.dat>>