 
I got an Accel Supercoil, the generic one for electronic ignition, and it
has worked very well.  I think it was only $18 as well.
Congrats on the brief run!
Just to confirm... you do have the correct model of plugs, right?  =)
-Dave
  ----- Original Message ----- 
  From: cruznmd 
  To: DMCForum@xxxxxxxxxxxxxxx 
  Sent: Monday, August 04, 2003 7:39 PM
  Subject: [DMCForum] HA!!! Crag make fire!!!
  Today, I dropped to my knees and thanked God for helping me start my
car.
  Well sort of...
  After soaking for 2 days in Marvel Mystery Oil my compression shot up
  to 150 psi. (For those who care, the specs are 114-156 psi, engine
  HOT, throttle wide open) Previously, it was 100-120 psi, but that's
  engine cold because the thing wouldn't start.
  At any rate, with fuel disconnected, and Marvel in the chamber, I gave
  it a shot of ether. It fired, struggled, then ran -briefly- (10-15
  seconds) on ether. The timing appeared correct, I didn't have time for
  the timing light but the engine chugged along without "fighting" itself.
  After that, the plugs fouled with Marvel and the starter wouldn't
  crank it fast enough. Battery's charging.
  I suspect my problems are two-fold. Low compression due to slow
  cranking, and weak spark. I'm going to replace the coil, wires and
  plugs with something hotter...18-20,000 volts, Bosch +4's and some
  good wires.
  Any other suggestions would be appreciated.
  Rich
  #5335 (on life support)
        Yahoo! Groups Sponsor 
              ADVERTISEMENT
             
       
       
  To unsubscribe from this group, send an email to:
  DMCForum-unsubscribe@xxxxxxxxxxxxxxx
  Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 
[Non-text portions of this message have been removed]
Yahoo! Groups Sponsor	 
ADVERTISEMENT
 
<http://rd.yahoo.com/M=244522.3656190.4921519.1261774/D=egroupweb/S=170512
6215:HM/A=1595056/R=0/SIG=124ps9ikp/*http://ashnin.com/clk/muryutaitakenat
togyo?YH=3656190&yhad=1595056> Click Here!	
 
<http://us.adserver.yahoo.com/l?M=244522.3656190.4921519.1261774/D=egroupm
ail/S=:HM/A=1595056/rand=419225166> 	
To unsubscribe from this group, send an email to:
DMCForum-unsubscribe@xxxxxxxxxxxxxxx
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service
<http://docs.yahoo.com/info/terms/> . 
<<attachment: winmail.dat>>
 Back to the Home of PROJECT VIXEN
 Back to the Home of PROJECT VIXEN