Re: [doc] Earth Lead and ECU

[Nick Tomlinson <nickandkathryntomlinson@xxxx>]

To Kevin,
Good luck, hope it cures the problem. I've just posted a pic of the ecu although its one of many I took. I am going to write an easy guide on how to repair them. If you can use a small soldering iron then it should be no problem. I am sure it maybe only 1 or 2 of the chips but as they are so cheap I just replaced them all. Saves time messing about. It takes my about 2 hours to fully repair and test one.
Nick.
"kevin_sar <kevin.milliken@xxxx>" <kevin.milliken@xxxx> wrote:Hi Nick 

I will look forward to your posting on the ECU. 

The Earth Lead I am using is a heavy grade cable and should take all 
the current and more, the next grade up is welding cable!

The problem with cleaning the strap to the cross member is that you 
would need to lift the engine of it mounts to get to the bolt. For 
normal purposes the earth lead is fine until you need the heavy 
current for cranking.

Regards


Kevin 


Yahoo! Groups SponsorADVERTISEMENT

DOC UK Website: www.delorean.co.uk
Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx
** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine ** 

Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service. 




---------------------------------
With Yahoo! Mail you can get a bigger mailbox -- choose a size that fits your needs


[Non-text portions of this message have been removed]