Re: [DML] How to get the Angle Drive off?

["Chris Parnham" <chrisparnham@xxxx>]

Andrei,

I did this job only last week, If you are lifting the car then you must be
working from the front of the car. I had success after unbolting the brake
calliper, swing it out of the way, then get a very heavy duty open ended
spanner ( I modified a very old one,witch has very thick jaws) and hammer
the spanner from above.
It is not left hand thread, but conventional.
Be sure to do it up tight again when you have done, because it holds on the
stub axle and hence front wheel!

Chris P DOC UK

----- Original Message -----
From: "Andrei Cular" <acular1@xxxx>
To: <dmcnews@xxxxxxxxxxxxxxx>
Sent: Tuesday, April 17, 2001 10:31 PM
Subject: [DML] How to get the Angle Drive off?


> I wanted to pull my angle drive off to lube it up but cant get the nut
off.
> I had a 5ft cheater bar and had my brother help me. We ended up lifting
the
> car.... Is it maybe a reverse thread? I have been soaking it with
> pentrating oil and will continue to till SAT when I can work on it again.
> If that doesnt work does anyone have any ideas or tricks short of pulling
> the wheel bearings and heating it with a torch?
>
>
> Andrei
>
>
>
>
>
> Before posting messages or replies, see the posting policy rules at:
> www.dmcnews.com/Admin/rules.html
>
> To address comments privately to the moderating team, please address:
> moderator@xxxx
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>