When removing the old one, be careful to cleanly cut the end at the throttle before pulling it through. If there're any frayed ends, they can break of inside the sleeve and prevent the new one being threaded in. Just a warning Martin Richard Hutchinson wrote: >The bobble on the spool end is just to stop the wires fraying I guess, >mine doesn't have one - use lots of heat, and just solder the tip > >The cable takes quite a convoluted route, use light oil along the >wire... > >No idea how much, I've not replaced mine, but it's the same wire as for >the bonnet catch. Get 5m it's cheap enough, then you'll have spare for >bonnet too :) > >Rich H >DOC 365 VIN 1274 > > > ------------------------ Yahoo! Groups Sponsor --------------------~--> Get fast access to your favorite Yahoo! Groups. Make Yahoo! your home page http://us.click.yahoo.com/dpRU5A/wUILAA/yQLSAA/HliolB/TM --------------------------------------------------------------------~-> DOC UK Website: www.deloreans.co.uk Unsubscribe: doc-uk-unsubscribe@xxxxxxxxxxxxxxx ** Unless otherwise stated, all messages posted to the group are assumed public and may be printed in the club magazine ** Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/doc-uk/ <*> To unsubscribe from this group, send an email to: doc-uk-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/