I need to get my tamper proof plug opening clear so I can try to correct a mixture problem. I'm not sure what the factory plug looks like, but I don't think that is what I have. It looks like there are threads going down the inside of the hole, then a metallic mass - maybe the remnants of a screw and the head has been stripped out or maybe JB Weld or similar - its hard to tell especially when I don't know what either the virgin hole or the original plug look like. I'm about to get some duct tape sticky side up under the hole, get the shopvac running next to the hole, and just drill it out. If this is a bad idea somebody stop me. Does anyone have a close-up photo of the hole with and without the factory plug installed? When all is done can I carefully seal it up with some ultra copper silicon? Tom #10902 To address comments privately to the moderating team, please address: moderators@xxxxxxxxxxx For more info on the list, tech articles, cars for sale see www.dmcnews.com To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews Yahoo! Groups Links <*> To visit your group on the web, go to: http://groups.yahoo.com/group/dmcnews/ <*> To unsubscribe from this group, send an email to: dmcnews-unsubscribe@xxxxxxxxxxxxxxx <*> Your use of Yahoo! Groups is subject to: http://docs.yahoo.com/info/terms/