Joe (and list), Supposedly any locksmith can cut the keys by code if they have a computer cutter. You shouldn't -have- to mail or give them blanks but I am personally experiencing a lack of those blanks among my local locksmiths. I also declined to use them because I think $40-100.00 for 5 minutes of work and a piece of potmetal is too expensive. To my knowledge, DMCH will not only sell the blank, but have them cut for you if you request it. PJ Grady may also but I have not specifically heard them say so, or heard of anyone else having them do it. Ken Creason is on this list and he also does it for a very reasonable price. He also has the blanks so you don't need to mail them to him unless you want a DMC logo head reproduction key cut. FYI: One compatible blank is the Ilco X29. The nice thing about Ken, is I was able to contact him on a weekend, which saved me mail time. I hope this helps, Rich #5335 --- In dmcnews@xxxxxxxxxxxxxxx, "dmcyoseppi" <dmcyoseppi@xxxx> wrote: > Where would one mail keys to to have them "cut" by code? What > necessary info would be needed? I have 2 Deloreans and I am tempting > fate by only having one working set for each. Have plenty of blanks, > but every time I try to use a hardware store they cut them with to > sharpe an edge to the keys and it will not turn in the cylinders. I > would rather just use my remaining DMC blanks and have them cut by a > pro. So where would I need to send them along with what information? > > Thanks, > > Joe O'Brien [long quote trimmed by moderator]