Re: Walkthrough for Replacing Slave Cylinder? Need one bad
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Walkthrough for Replacing Slave Cylinder? Need one bad



Removing the engine cover is also a big help. Put towels over the
stainless steel so you don't scratch it leaning over.
David Teitelbaum
vin 10757

--- In dmcnews@xxxxxxxxxxxxxxx, Travis Goodwin <tgoodwin@xxxx> wrote:
> I replaced the slave cylinder from under the car and it kicked my
ass. The
> clutch spring was tight and makes it very difficult to get the slave
> cylinder in there, especially when you can't see it!
> 
> However, if you remove the intake manifold the slave cylinder is sitting
> right there within arms reach. I know it's not a pretty prospect,
but the
> intake is easier to remove than you might think.
> 
> > -----Original Message-----
> > From: Michael Paine [mailto:mpaine@xxxx]







Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated