Re: Stalls after starting
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Stalls after starting



The first thing that comes to mind would be to check the control
pressure regulater aka the warm-up regulater. Make sure all the vacuum
hoses are routed correctly and not leaking. You could also have a
problem with the thermister that tells the idle ECU to raise the idle
when cold. It is hard to get to under the intake but you might be able
to see if the plug is attached. You could check the resistance at the
ECU plug.
David Teitelbaum
vin 10757



--- In dmcnews@xxxxxxxxxxxxxxx, "painintheass7565" <advantics@xxxx> wrote:
> Howdy. I have two D's and one runs like a top and one has this 
> problem. I starts right up but unless I keep my foot on the gas it 
> stalls out. It will bounce back and forth between 500 and 1000 RPMs 
> for a few seconds before it stalls. If I give it a little gas for 
> about three minutes, it goes to a steady idle and is fine. If not 
> given the 3-4 minutes of gas to warm up it would stall out. Driving 
> expirience is great once I get to go, but my intention is not to look 
> good in the parking lot but on the road.






Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated