My Gauge was stuck too. Turned out a diode was fried on the RPM Gauge's Circuit board. Tried to find a replacement board but had no luck with that... Purchased a new Gauge from DMC Houston. This solved my problem. Chris Hammond Vin 1882 > > From: Travis Goodwin <tgoodwin@xxxx> > Date: 2003/04/29 Tue PM 01:21:15 EDT > To: "'dmcnews@xxxxxxxxxxxxxxx'" <dmcnews@xxxxxxxxxxxxxxx> > Subject: RE: [DML] RPM guage sticking > > Have you worked behind the binnacle recently? Could be an electrical > connection in the back, but this would be the last place I check (since it's > such a pain to take the thing off). > > > -----Original Message----- > > From: dmcorlando2003 [mailto:SundeQuick@xxxx] > > Sent: Tuesday, April 29, 2003 10:55 AM > > To: dmcnews@xxxxxxxxxxxxxxx > > Subject: [DML] RPM guage sticking > > > > Every now and then when I am driving my RPM needle just freezes. > > Sometimes it will jump a little before it freezes. Then after a few > > seconds it starts working again. Happens at all different speeds and > > times. Any ideas? >