I have a couple pedal boxes if you are interested. Erik --- In dmcnews@xxxxxxxxxxxxxxx, "Dave Swingle" <swingle@xxxx> wrote: > The frame is only different in the area of the shifter mechanism and > the difference is not difficult to overcome (with an air chisel or > some spacers, depending on which way you are going). I don't recall > which, but one mounts higher than the other. Worst case you'll have > to cut out and fabricate a new metal plate where the shifter mounts. > > You need to change the shifter, flywheel, pedal box including master > cylinder, trans mounts, and add the clutch line. That's about it. > Overall cost is all over the place depending on what you pay for the > parts. Buy the clutch assembly and all the hydraulics NEW. > > BTW - if you NEED a manual transmission for this effort, contact me > off-list. As part of a project we have come into a few good spares > that I'm rebuilding (open, clean-up, fix the rollpin, new seals > etc.). Rich or Eric G may also have a pedal setup - > > Another thought - it would probably be cheaper and easier to sell > your car and buy the right one. > > Dave Swingle dswingle(AT)dmcnews.com > > -- In dmcnews@xxxxxxxxxxxxxxx, "Rob Hook" <rob_hook@xxxx> wrote: > > Raphael, > > > > I haven't looked at it personally but I know the frame itself is > different > > for automatic and manual transmission DeLoreans. > > > > --Rob > > > > -----Original Message----- > > From: ferdaniraphael [mailto:raphael.ferdani@xxxx] > > Sent: Tuesday, March 18, 2003 12:40 PM > > To: dmcnews@xxxxxxxxxxxxxxx > > Subject: [DML] trans swap > > hello > > Anyone swapped his auto trans for a manual ? Except trans mounts and > > shifters, what parts are involved ? How diffcult is it ? > > thanks a lot > > Raphael > > > >