Re: [DML] Re: Cold help
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [DML] Re: Cold help



Dale, When your working on 7,8,10mm 1.0 pitch fine threads it doesn't take a 
lot of tightening to strip a thread. Some people when working on cars screw 
thing s down till the aluminum wants to strip out the threads. Just tighten 
them down snug. There are rubber O-rings on them so they don't have to be 
torque to 5, 10 or so LB's. Just tight.
John Hervey
www.specialTauto.com



<< I'm even more confused about this than you.
Does this mean open them all the way then turn them "lightly". Is lightly a 
quarter turn or a half turn or a full turn? Does closed lightly mean they 
should be nearly all the way closed then barely not closed?
Dale Funk
vin 4984

>>





Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated