Re: [DML] Fan Speed
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [DML] Fan Speed



Make sure that the fan is rotating in the correct direction. If not 
you will have to reverse the wires going to the motor. Check that all 
of the actuaters are working, a vacuum leak or a hissing mode switch 
will affect the actuaters from moving correctly. The different speeds 
are controlled by the fan speed switch selecting the different relays 
and not different taps on the motor. Make sure all of the ducts are 
connected, a missing or badly fitted duct will allow too much air to 
escape and you will have less comming out the vents. This means check 
the seals going to the doors and the duct inside going to the vent on 
the door panel.
David Teitelbaum
vin 10757


--- In dmcnews@xxxx, Mark Noeltner <mark@xxxx> wrote:
> There is a rubber boot that connects the rear of those two center 
vents to
> the main air duct behind the dash. Have you verified that the boot 
is
> connected properly? I had this problem after a radio install and 







Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated