Re: [DML] angle drive ring clip
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [DML] angle drive ring clip



Where exactly does the "ring clip" go? I removed my original drive and there
was no clip on that assembly. My new unit with updated cable bracket came
with a small spring-steel circular retaining clip. The workshop manual
mentions it but does not elaborate on its installation. Can anyone clarify
this?
Thanks,
Rustproof
Vin#1559
----- Original Message -----
From: "Sean Howley" <delorsche@xxxx>
To: <dmcnews@xxxxxxxxxxxxxxx>
Sent: Saturday, September 14, 2002 11:40 PM
Subject: Re: [DML] angle drive removal question


> After I removed the cable (that goes to the instrument cluster), I used a
1
> 1/4 box end wrench to loosen the large nut on the back side of the
spindle.
> To remove the angle drive without damaging it, I had to rotate it into a
> position that would allow it to pass in-between two of the spring coils.
It
> was actually much easier of a job than I had expected. Installation is
the
> reverse - just make sure that you torque the angle drive nut back
properly.
> That is pretty much it!
>
> Sean Howley
> VIN#2345





Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated