RE: [DML] Head assemblies
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [DML] Head assemblies



i think you can go up to .0025" but i may be wrong, i havent machined heads
in a long while

Darkstar

-----Original Message-----
From: MPolzin@xxxx [mailto:MPolzin@xxxx]
Sent: September 11, 2002 2:03 PM
To: dmcnews@xxxxxxxxxxxxxxx
Subject: Re: [DML] Head assemblies


> I will definitely be looking into this process as well as having
> them planed flat. I guess I was just being overly cautious thinking
> of just replacing them, but this isn't anything new, and certainly
> for the price I should give it a try.
>
> Is anyone aware of the maximum amount (in microns) that you can
> shave off these things before you are going to run into problems?
> I'm not sure how badly they are warped, so that might be the only issue.
>
> Has anyone ever warped the block due to overheating? I'm wondering if
> I need to check that too.
>
> Mike Polzin
> VIN #4761

[moderator snip]





Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated