Hello again, Since I was busy with the pictures of the RPM-relay I also put up pictures of my finished monitoring-panel *(you might rememer me asking for inspiration a couple of months ago). The monitor is up at <http://members.home.nl/delorean/monitor> As promised I have now put pictures of my RPM-relay modification up. They can be found at <http://members.home.nl/delorean/rpm/> - The first picture is what I see when nearing the car, this flashes to let me know the alarm is activated. - The second picture was taken with the engine running and hot engine; both fans are running, as is my fuelpump and the tem is still too high. - When the temp gets low enough the otterstat cuts out and my fans sequence down, in the 3rd pic you can see that only fan 2 is still running thanks to FanZilla (I LOVE to see this!) - The actual Icon Design is shown in pic 4, I can't demonstrate the AC-light, since my AC doesn't work at the moment, but the symbol cycles with the clutch. - The 5th pic shows the new window I made, still on my work bench, looks allmost stock, doesn't it?!? - Most asked question is how I fixed the window; you can see here! The plastic has a hole in it that's smaller than the window, the window sits on top of the plastic and is glued in place. I made a Circuitboard that screws into the hollow posts seen at the bottom. - These are the actual LED-elements, each square contains 4 chips, which I put in series per square with a resistor to determine the current. - The board from below, with the wires connected, tinned tracks and a couple of shrinkwrapped resistors... I'm very happy with this setup; it's proven more usefull to me than the original clock and has helped troubleshooting on both (allmost) overheating my engine and some no-start (RPM-relay) trouble. Any questions are welcome, JAN van de Wouw Thinking Different... Using a Mac... Living the Dream... Driving a DeLorean... #05141 "Dagger" since Sept. 2000 ------------------------------