Message: 4 Date: Tue, 25 Jun 2002 03:38:47 +0100 From: "Chris" <chris@xxxx> Subject: Rivnuts What's the best way of removing Rivnets?, I have one where the bolt is solid in the rivet but the bolt has no head, and the other bolt has a head but again the bolt has seized into the rivnut and the Rivnut turns in the underbody. Any ideas? Thanks Chris S Vin 16327 Chris, The only way to deal with it,is the cut or chisel the head with a die grinder or dremmel tool, with a little cut-off wheel,then PUSH the body of the rivitnut INTO the fiberglass body,UNDER NO circumstances try to pull out the rivitnut,as you will cause fiberglass damage,as the rivitnut is in a compressed state,and therefore,the inside area, is BIGGER than the hole that it was originally inserted into,once pushed into the fiberglass body,you are now ready to install a new rivitnut. Claude 00570