Re: [DML] fast idle,problem found(I think)
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [DML] fast idle,problem found(I think)



Well, I can help with part of this. The door panel is actually 2 pieces.
The upper piece comes off really easily. You just need to pry it up - up
where it meets the window. There are these little "fir tree" fasteners
that hold the panel to the door.

Once that part is off, to get to where the window regulator is, you need
to take off the rest of the door panel (lower panel). The trickiest part
are these 2 10mm bolts that are right near the door handle. To see them,
you'll need to take out the mirror switch. One of the bolts is directly
under it. The other one is about 5 or 6 inches further back toward the
back of the door. You see these bolts by looking "down", which is a little
bit subjective when talking about gullwing doors. But if the door was
closed, you want to look down toward the ground - not in, as if looking
out the window (that was my big mistake).

After those bolts are out, there's also 4 or 5 obvious screws that were
hidden by the upper door panel. Then around the sides and bottom it's just
more "fir tree" fasteners. It's much easier done than said.

Of course, before you take the door apart, make sure it's not a problem
with your window switch. Take the passenger switch and plug it in to the
driver door wiring. Always take the door apart as a last resort (as it's a
big pain in the butt).

-Christian

On Sat, 1 Jun 2002 Meyerleem@xxxx wrote:

> Thanks to all who responded to my idle problem. I took off the "w" pipe and
> looked at the throttleplates as was suggested. The right throttle plate is
> definately bent and the left one also appears to be slightly bent. I assume
> this is from the backfire I had when tring to start the car. I also found
> that the plates were not opening fully and plan to fix this at the same time.
> I'm guessing that this is just an adjustment in the rod. anyway, i'm looking
> for the best place to buy new plates and gaskets including the rubber?
> gaskeeet under the throttle body. Any suggestions? Also my left side window
> decided not to operate this spring so how does the door panel come apart?
> Thanks
> Lee meyer
> #1699
>
>
> To address comments privately to the moderating team, please address:
> moderator@xxxx
>
> To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/
>
>






Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated