RE: [DML] Trailing Arm Bolts - Update
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

RE: [DML] Trailing Arm Bolts - Update



Toby and list,
As a member of the PNDC I would also like to thank FAME Automotive for letting us use their facilities. We (PNDC) had two hoists and two other work bays for us to use, as well as a REAL mechanic on hand for tecinical questions. The club also put on door struts, adjusted doors and found bad idal bearings (mine). Oh, I almost forgot, I saw a fan set up that looked almost factory and it was an after market buy. The set up did not take up as much room nor did it take as much power to run. I think Darrel Tinnerstet got the low down and part numbers.

Jim Sawyer
vin 4149 
"tmpintnl" <tobyp@xxxx> wrote:

>Hello List - PNDC just had a fantastic Spring Tech Session, and we 
>gained some more experience with our nemesis, the TAB. ?16 members 
>were in attendance, and about half a dozen wanted to get some TOBY-
>TAB's installed. ?(Most of the rest already had them in.). ?





Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated