Re: [DML] EFI Custom Intake Winter Project
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [DML] EFI Custom Intake Winter Project



Sounds like great work Jim. Later 2.8s went with a big intake manifold. eg. Puegot 504e. It made 185 HP. Should be interesting to see what you get.

You should install one of those catalytic converter test pipes. Its worth about 5-10 HP based upon the ratings of the euro version.

BOB

jwit6dmc12 wrote:

Hello all,
I wanted to share with you what I've managed to accomplish over the winter. When my clutch slave cylinder failed I removed the intake manifold to replace it, and before I knew it I decided to fabricate a new intake for use with my EFI setup. I also replaced the alternator, rewired the engine compartment and replaced the exhaust system with a polished stainless steel Supertrap.


There's a picture on the second page of the photos section called EFI Intake.

After I had the original intake off I realized that with a 90 degree v 6, everything is perfectly square. No fancy angles. And with the o-
ring seals on the heads it seemed like a reasonable project to undertake. Anyway if it failed I could just go back to the stock intake. But it's such an ugly thing that I really didn't want to give up.


Anyway, the intake is all aluminum, mostly flat 1/4 inch shaped in a 90 degree V with 6 independent aluminum intake runners whose inside diameters match the intake ports.

All the CIS wiring, sensors and switches are gone, and it really cleaned up the engine compartment. While I was at it I also moved my previously installed EFI ECU trigger from the coil to a Hall effect sensor on the crank pully. Also installed a new Accell Super Stock ignition coil.

The intake uses twin throttle bodies from 1990 Ford Tempos. Both courtesy of the bone yard. Very economical. Idle air valve is courtesy of a Porsche 914. Injectors are Accell 24 lb high impedence. Fuel rails are extruded aluminum. All custom. This would not be possible if I didn't have my own metal working lathe. Although extruded rails are available from Accell and all you have to do is have you local machine shop machine the injector seats for you (4 1/4 inch centers....)

Air filter assy is a K&N in an Edlebrock dual quad oval with custom machined fillers to fit the smaller Ford throttle bodies. TPS is a 3 wire Ford and is a direct bolt on. Engine temp and air temp are from Simple Digital Systems (along with the ECU) and the MAP sensor is standard GM 1 bar. (Although you could use the stock Bosch water temp if you wanted)

With the new intake and the Supertrap I had to bump up the mixture values from what I used with the stock intake and exhaust about 10%, so I suspect the engine is breathing a little better. It sounds quite a bit different. Noticable intake roar under full throttle acceleration. Still using the stock cat.

Fuel delivery to the filter and then to the fuel rails is all stock except that I removed the fuel accumulator since it was dirty anyway. Fuel pressure regulator is a stock Nissan 240 ZX and runs at 43 pounds.

Hope to have it on a Dyno soon to finalize the mixtures and see what kind of power it makes.

Hope you enjoy the info....

Jim Vin 6147

To address comments privately to the moderating team, please address:
moderator@xxxx

To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews

Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/









Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated