_start_ by checking the plastic hub cap (take off the left front wheel). This cap should fit snugly into the hub. Check the square hole in the centre - is it still nicely quare or is it rounded off? If it's square and the fit is snug, try turning the cable end by hand - it should be stiff but movable. You could try spinning it in the chuck of an electric drill , though if the angle drive has siezed, you'll most likely break it by doing this! Martin #1458 brucedduncan wrote: > where do i start? (but i presume i will probably end by buying a > $200 part :) ) > > thanks > bruce > 1265 >