Re: [DML] Radio removal?
[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [DML] Radio removal?



>i couldn't figure out how to get
>the rubber vent to fit back together. Any suggestions?

With the vent assembly removed, install just the rubber boots, properly 
oriented (they are not symetrical), to the dash board duct work. Remove both 
vent assemblies from the vent assembly housing by gently prying them out 
towards the front, at the end where the pivot detent is located. Be careful 
to note how the star shaped retainer at the opposite end is assembled to the 
vent as it may fall off when you pop out the vent. Install the empty vent 
housing and massage the boots onto the housing through the now wide open vent 
openings. Then pop the vents back into the housing assembly with the star 
shaped retainers properly oriented.





Home Back to the Home of PROJECT VIXEN 


Copyright ProjectVixen.com. All rights reserved.

Opinions expressed in posts reflect the views of their respective authors.
DMCForum Mailing List Archive  DMCNews Mailing List Archive  DMC-UK Mailing List Archive

This site contains affiliate links for which we may be compensated