Re: [DML] Brake Lights (again)

[Les Huckins <jhuckins@xxxx>]

Take the board out and apply 12V to the stop light strip. Do they light? No? Remove a
bulb and apply 12V to it. Bulb ok? Run a continuity test from strips to sockets and/or
read the voltage at the socket. Still ok? Check input voltage at the stoplight switch.
OK there? Bridge the switch and see if your stoplights come on. Yes? Check for proper
positioning or Replace the switch. No? Bad connection or wire. (I'm assuming you
checked the fuse first, right?)

Willie Mack wrote:

> Alright guys, my brake lights still don't work. I took them apart and
> looked at them closely. It appears that the previous owner tried soldering
> the bulb sockets back to the board, because every socket has a little piece
> of solder on it. It is safe to rule that out as a possibility? Where else
> could i look for the solution?
>
> Thanks
> Willie Mack
> Vin 5043
>
> To address comments privately to the moderating team, please address:
> moderator@xxxx
>
> To search the archives or view files, log in at http://groups.yahoo.com/group/dmcnews
>
> Your use of Yahoo! Groups is subject to http://docs.yahoo.com/info/terms/