You just happened to find one of the "missing" parts that don't hardly show up anywhere. Refer to Workshop Manual J:02:01 fig #4. You are probably missing the speedo drive cap. Remove the front left wheel and it is supposed to be in the center connecting the square rod from the ange drive to the spindle assembly. It is captured in between the rim and the spindle when the wheel is installed. Usually it isn't missing but the square hole in the center rounds out allowing the wheel to turn without turning the angle drive. I am suprised that the vendor you purchesed the parts from didn't mention at least checking it before ordering the other parts since when parts are missing you don't always know what to expect and even if it's there it was possibly worn out. To test the parts you already have just put a drill on the square of the angle drive and you should see the speedo move. (Make sure to turn in the correct direction, CCW). David Teitelbaum vin 10757 --- In dmcnews@xxxx, "Paul Salsbury" <paul.salsbury@xxxx> wrote: > All happy with myself, I just purchased the bottom half of the Speedo cable and an Angle-drive, both missing when I got the car :-( . > Just been out to fit them ...all when OK except the Speedo is still not working. On closer inspection it looks as if the wheel is not turning the angle drive....... I can see right through where the drive rod goes on to the Speedo nut(105027) it looks like the should be a part for the square end to goes into, and I can't see it in the parts manual. > > Please tell me its something really easy I'm over looking. > > Cheers > Paul > > VIN6463 > > > [Non-text portions of this message have been removed]