This is a tough one. I wouldn't do it without the workshop manual, but here goes nothing... I did it just this past weekend to repair the window. Once you remove the trim panels, you can access everything. If you roll the window down, it will help, but it's not necessary. On the top trim panel, start on the edge and pull the trim up. There are about 8 nylon tree rivets that are holding it in place. A long screwdriver would help too. The whole trim panel should lift up and out of the way. For the bottom trim you need the longest magnetic phillips head scewdriver you can find (18" would be good). Unscrew all the screws holding it down and pop the tree rivets loose at the bottom. Now, pull the panel away from the door far enough to access the handle screws (one on each side). Using your long screwdriver, unscrew them and the panel will fall free. Once both of the trim panels are off, you can see the window mechanism to remove it. > Message: 19 > Date: Sun, 5 Aug 2001 09:00:37 -0700 (PDT) > From: Doug Hornsby <govenorofvirginia@xxxx> > Subject: how do you take the driver's door apart - fix window > > Is there a place where I can find out how to take the > driver's door apart and replace the toll booth window > mechanism. I have the part but do not want to start > without some advice. Thanks. > -=DH=- > vin 2912 > > __________________________________________________ >